Cipia Vision Ltd.
–
Proprietary & Confidential
Page 37 of 38
7.
Standards and regulations notices
7.1.
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses and can radiated radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment. This equipment must be installed and operated in accordance with provided
instructions and the antenna(s) used for this transmitter must be installed to provide a separation distance of at least
20cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.
FCC ID:
✓
FS10-LOC/FS10-LOC-ADS:
2AZIQFS10L
✓
FS10-LTE/FS10-LTE-ADS:
2AZIQFS10C
7.2.
IC
(EN)This device complies with the applicable industry Canada) License exempt radio apparatus, the operation is
authorized under the conditions as follows: (1) this device may not cause interference, and (2) the user of this device
must accept any interference caused, even if the interference is likely to affect its performance.
(FR)Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
(EN)Radio frequency (RF) Exposure Information The radiated output power of the Wireless
Device is below the industry Canada (IC) radio frequency exposure limits. The Wireless Device should be used in such
a manner such that the potential for human contact during normal operation is minimized. The device has also been
evaluated and shown compliant with the IC RF Exposure limits under mobile exposure conditions (antennas at least
20cm from a person’s body)
.