W
ir
e
le
ss
F
u
z
z
y
S
c
a
n
R
e
fe
re
n
c
e
M
a
n
u
a
l
Getting Started
6
Clone Function
For the user’s convenience, the clone function will help you to clone the host interface related parameters (please refer to
following table for details) from one of the paired scanners to the rest of paired scanners under PICO mode. You can use
one of the paired scanners to set the host interface related parameters first and then scan “Save Configuration” command.
After that, please take the other paired scanners to scan “Clone” command one by one to clone the host interface related
parameters.
Please ensure to keep those paired scanners in connected status when you use the “Clone” function. Because the host
interface related parameters can’t be cloned to the paired scanner in disconnected status.
Save Configuration
Clone
The below host interface related parameters will be impacted by clone function:
Data Transmission Parameter
Serial Interface Control
Field Delimiter
Handshaking Protocol
Data Transmission Format
Intermessage Delay
Host Interface Control
Interfunction Delay
Host interface Selection
Intercharacter Delay
Keyboard Interface Control
Baud Rate
Keyboard Layout
Data Frame
Intermessage Delay
Time Out Control
Interfunction Delay
Wand Emulation Control
Intercharacter Delay
Output Polarity
Caps Lock Control
Initial Signal State
Caps Lock Release Control
Margin Time
Function Key Emulation
Module Time
Key Pad Emulation
Narrow/Wide Ratio
Upper/Lower Case
Code39 Emulation
