6
CARE AND MAINTENANCE
Inspect the grill regularly to make sure that all parts are functioning properly.
Replace all broken or worn parts.
Burn-off grease build-up by operating the grill at maximum heat setting for 15 minutes
at the end of each use.
Empty or replace grease drip can at the end of each use.
Clean the grill body, control panel, handles and legs with mild detergent.
Check and remove any dust, debris or spider webs from the burner venturi.
Inspect the hose. If it is evident there is excessive abrasion or wear, or the hose is
cut, it must be replaced immediately. The replacement hose assembly must be that
specified by the manufacturer. Refer to the last page.
Light the appliance, after reading the LIGHTING PROCEDURES section of these
instructions. The burner should light immediately, and be viewed from both sides to
exhibit blue flames with occasional yellow tips. These should extend along the full
length of the single burner.
Replacement parts are available from the manufacturer, through your distributor.
Refer to the contact details on the last page if experiencing difficulty.
STORAGE
Disconnect the LP cylinder from the grill when not in use and store the LP cylinder as
instructed by labels located on the cylinder. DO NOT store the LP cylinder in an
enclosed area and NOT within the reach of children.
Complete the procedures in `CARE AND MAINTENANCE` before storage.
Store the grill in a clean and dry location.
