CIGWELD Transmig 355i, Руководство по эксплуатации, Страница: 46 / 116

OPERATING MANUAL
MIG (GMAW) WELDING 5-4 Manual 0-5586
5.02 Optional Wire Feeder Controls, Indicators and Features
The optional 4RX Wirefeeder is designed to be used with the Transmig 355i. Select MIG Process and REMOTE
10P in Advanced Features to enable the controls on this wirefeeder. Set Internal Switch to <1>Local / 4RX /
Spool Gun position. There are two controls on the 4RX.
1. The Left Knob controls Wirespeed in this wirefeeder. It adjusts the preview wire speed display in the
power source.
2. The Right Knob controls the Volts in the power source. It adjusts the preview volts display in the power
source.
In Auto MIG mode the Right Knob also controls the Heat Control Value and the value is from -5 to +5,
turning the Voltage Control knob clockwise increases the voltage along the Heat Scale, and the voltage
control knob will adjust the heat setting off the Auto MIG synergic line (which is set at 0 on the Heat
Control).
Description Transmig 4RX Wirefeeder
Wirefeeder Plant Part Number W3000410
Wirefeeder Plant Dimensions H 453mm x W 238mm x D 553mm
Wirefeeder Plant Mass 21kg
Wire Feed Motor Voltage 24 VDC
Gas Solenoid Voltage 24 VDC
Minimum Wire Speed 1.5 MPM
Maximum Wire Speed 22 MPM
Operating Temperature Range 0°C - 40°C
Interconnection Plug 10 Pin
Interconnection Length 8 metre
WFS Control
Volts Control
Euro Connector
8 Pin Remote
Connector
Art # A-14704
Figure 5-3: 4RX Front Panel Controls
The Tweco professional MIG Torch will connect to the 4RX just as it does to the 355i power source. The
electrode Polarity setting is done at the power source. See sections 5.13-5.17.