CiDRA AIRtrac, Руководство по установке, эксплуатации и поддержке

Страница: 23 / 52

21798-01-EN Rev 02 Page 21
4.3.4 Battery Installation
Only batteries specified by CIDRA should be used in the AIRtrac
Mobile sensor, CiDRA P/N 21809-01, 7.2VDC, 98Wh.
To replace the AIRtrac Mobile sensor battery, remove battery cover by
loosening four (4) one-quarter turn screws (Figure 12), lift the battery
cover off and remove the battery from the sensor.
Check that the battery charge indicator located on end of the
replacement battery shows five bars indicating full charge (Figure 11).
Line up the battery terminals and insert the battery terminal side first
making sure it is fully engaged and secure. Replace battery cover and
securely tighten four (4) one-quarter turn screws.
The spare battery should be stored in the battery charger so it is
always charged.
Figure 11: Battery Charge Indicator Showing Full Charge and Battery
Terminals
Figure 12: Battery Cover Installed, and Removed Showing Battery
Compartment