CID X-TREME XBC60LF, Руководство пользователя

Страница: 21 / 52

X-treme Brush Cutter
January 2021
21
After starting skid steer, lift attachment 6 inches off
the ground surface:
1. With the skid steer engine RPMs just above idle, activate the skid
steer’s auxilary hydraulic system.
2. Allow the cutter to run for 30 seconds to purge air from the system,
then turn off hydraulic flow to the brush cutter and allow it to come
to a complete stop.
3. Lower the brush cutter to the ground, set parking brake, shut off the
skid steer’s engine and exit the operator’s compartment.
4. Check the skid steer’s hydraulic oil level, add oil if necessary.
5. Inspect the brush cutter hydraulic plumbing for any noticeable leaks.
Fix leaks before continuing.
6. Restart the skid steer, then set engine to slightly above idle.
7. Raise brush cutter off the ground and engage the hydraulic flow
switch. Allow cutter to come up to speed before increasing engine
3.4 First Time Use Procedure Cont.
A small stream of oil from a pinhole leak could penetrate your
skin if contacted. To avoid an accident that could result in Death
or Serious Injury, never use your hand or other body parts in an
attempt to locate a hydraulic leak.
Before operating the brush cutter, check the skid steers hydraulic oil
level and add oil if necessary.
6 inches