|
12
3.6.9 MAX HR limit
Please note: If you use CICLO
InZone
®
you don’t need to change the Lower/Upper/Max HR.
Here you can change the upper heart rate limit.
Set with the middle and right button, store with left button.
3.7 Sensors
You can connect different ANT+ sensors to the CM 9.3 A (+). To use an ANT+ sensor, you first have to
initialize it.
3.7.1 How to initialize a sensor
In the main menu press the left or the right button until
SENSORS
is displayed, continue with middle button.
You can use the following sensor types with the CM 9.3 A
Select the sensor you want to initialize and press the middle button.
Now
INISCAN
is displayed in the lower display.
Now please make sure that the sensor starts to send. Put on the heart
rate sensor or move the crank or Wheel. Press the left and right button
simultaneously to start the sensor search. As soon as the sensor is found, the CM 9.3 A will display
“
connected
” in the bottom line. If no sensor of the selected type can be found it shows “
fail
”
In the sensors menu a check mark after the sensor type shows that a sensor has been initialized.
To remove a sensor go through the above procedure and make sure that no sensor is near. After the search
failed the sensor that was initialized before will be deleted and the check mark disappears.
3.7.2 Power measurement calibration
If you use a power sensor that requires a calibration, select
power
in the sensor menu and press the middle
button. When
INISCAN
is displayed, press the right button to enter calibration mode. Press the middle but-
ton to start the calibration. The CM 9.3 A will show “
Success
” in case the calibration was successful.
Chapter 3 – settInGs & fIrst start
Speed
Cadence
Combo Sensor (Speed./Cadence)
Heart rate
Power measurement
