CIAT MAJOR LINE, Инструкция по эксплуатации

Страница: 33 / 128

EN
EN-7
N 09.60 F
*HQHUDOVDIHW\LQVWUXFWLRQVIRUXQLWVZLWKHOHFWULFKHDWLQJHOHPHQWV
z
)DQDVVLVWHG RSHUDWLRQ WKH HOHFWULF KHDWHU RU UHVLVWRUV PXVW DOZD\V EH
assisted by a fan. Power to the electric heating elements should be cut and post-
ventilation activated whenever the fan motor assembly is stopped intentionally or
unintentionally.
z To ensure correct operation of the system and its safety devices when used with
hot water and the electric heating elements, only low-temperature ranges are
recommended.
z Two temperature limit thermostats protect units with heating elements from
accidental overheating
ILJD DQGDUHDOZD\VILWWHGRQWKHHOHFWULFDOER[VLGH
Do not reset these thermostats until the potential causes of the overheating have
been identified:
> Turning on the unit without the fan.
> Filter partially clogged.
> Coil and fan stopped simultaneously by control.
,PSRUWDQW
Never wire several fan motor assemblies in parallel on the same thermostat.
,03257$17127(%586+/(6602725
The electrical connection for CIAT Comfort Units must be made in compliance with
LQWHUQDWLRQDOVWDQGDUG,(&(OHFWULFDO,QVWDOODWLRQVIRU%XLOGLQJV
The leakage current for all our Comfort Units complies with the requirements of
VWDQGDUG,(&+RXVHKROGDQGVLPLODUHOHFWULFDODSSOLDQFHV6DIHW\
&RPSOHWHFRPIRUWXQLWZLWKHOHFWULFDOKHDWHUVHTXLSSHGZLWKDPXOWLVSHHGPRWRU
PD[LPXPOHDNDJHFXUUHQW P$
&RPSOHWHFRPIRUWXQLWZLWKHOHFWULFDOKHDWHUVHTXLSSH((PRWRU
%UXVKOHVVWHFKQRORJ\PD[LPXPOHDNDJHFXUUHQW P$
&21'(16$7('5$,13$1
The MAJOR LINE is equipped with a sloping polymer pan which does not retain
ZDWHU¿WWHGZLWKD‘PPH[WHUQDOGUDLQHQGSLHFHDQGDSOXJ
:KHQWKHXQLWLVGHOLYHUHGWKHSDQLVEORFNHGRQERWKVLGHVSOXJVVRLWLVWKHUHIRUH
imperative that the plug is removed from the side where the hydraulic connection is
to be made.
,IWKHK\GUDXOLFFRQQHFWLRQVLGHLVVZLWFKHGGRQRWIRUJHWWRUH¿WWKH
SOXJWRWKHVLGHQRWXVHG
The connection can be made on the left or right-hand side of the unit.
The drain hose can be separate for each unit or corrected to a main drain hose. Use
a clear and/or rigid drain hose for a minimum slope of 1 cm/m, with a constant level
along its whole length. Install a trap measuring at least 5 cm to prevent unpleasant
JDVHVRURGRXUVH[LWLQJWKHKRVH
!