CIAT Divio, Инструкция по установке и обслуживанию

Страница: 8 / 18

EN - 6
2. INSTALLATION
2.1 Positioning the unit
Avoid installing the unit close to:
- places subject to exposure to direct sunlight;
- sources of heat;
- damp areas or places likely to be in contact with water;
- places with oil fumes
- places subject to high frequencies.
Make sure that:
- the wall on which the unit is to be installed is strong enough to support the weight;
- the part of the wall in question does not have pipes or electric wires passing through;
- the wall in question is perfectly flat;
- the area is free from obstacles which could interfere with the inlet and outlet air flow;
- the installation wall is preferably an outside perimeter wall to allow the discharge of the condensation outside;
2.2 Installation modes
The following descriptions of the various mounting phase and the relative designs refer to a version of the machine with fixtures
on the left. The descriptions for assembly operations.
To ensure that the installation is carried out correctly and that the appliance will perform perfectly, carefully follow the instructions
indicated in this manual. Failure to respect the rules indicated will not only can cause the appliance to malfunction but will also
void the warranty and hence CIAT shall not be responsible for any damage to persons, animals or property.
It is essential that the electrical installation is made according to the laws in force, respects the data indicated in the technical
sheet and is correctly earthed.
The unit must be installed in a position which allows ordinary (cleaning of the filter) and extraordinary maintenance, as well as
acess to the bleeds that are accessible via the upper grille.
2.3 Opening of sides
- Dismount the upper grille (fig. 5 ref. A) by unscrewing the two fixing screws (fig. 5 ref. B).
- Open the side inspection flap (fig. 5 ref. C).
- On the left-hand side loosen the screw (fig. 5 ref. F) that fixes the left panel (fig. 5 ref. G), then lift it up and move it slightly to
the left.
- On the opposite side, lift the cover (fig. 5 ref. H) that protects the screw (fig. 5 ref. L) and unscrew it.
- Move the side panel slightly to the right and lift it out (fig. 5 ref. P).
A
B
B
F
G
C
L
H
P
Fig. 5