ENGLISH
DECLARATION OF CONFORMITY
(EMC Directive 89/336/EEC)
(LV Directive 93/68/EEC)
(PE Directive 97/23/EEC)
The manufacturer:
CIAT
Avenue Jean Falconnier
Boite Postale N°14
01350 CULOZ - FRANCE
hereby certifies that the following machine:
AQUALIS 2
conforms to the requirements of the Low Voltage Directive
and the national laws transposing them.
Frédéric Bruyère
Cooling Department Manager
.
32
Français
English
Deutsc
h
Italiano
1.
GENERAL
1.1 Introduction
AQUALIS 2
air-to-water geothermal heat pumps are high-temperature packaged outdoor units. Each comes equipped as stan-
dard with:
- Low-noise scroll compressor.
- Brazed-plate heat exchanger.
- Air-cooled condenser.
- Variable-speed axial fans (cooling and heating).
- Hydraulic accessories.
- Complete electronic control.
They are factory tested and checked and are delivered charged with R410A refrigerant
.
1.2 Unpacking the equipment
Check the unit for any damage or missing components upon delivery.
Make mention of any damaged or missing parts on the delivery slip.
NOTE:
you must notify the carrier of any damage and/or missing parts by registered letter within three days of the delivery date.
1.4 Warranty
For information on obtaining service under the CIAT warranty,
please refer to the general terms and conditions of sale.
1.5 Safety recommendation
To protect against accidents while installing, commissioning
and adjusting the unit, the following parameters must be kept in
mind:
- pressurised refrigeration circuit
- presence of refrigerant
- presence of voltage
- location
- surface temperature as high as 150°C
Only experienced and qualified persons may work on this
equipment. The recommendations and instructions given in the
maintenance instructions and the special instructions on the
labels must be followed.
Always comply with applicable standards and regulations.
IMPORTANT
: make sure the power supply has been cut off
before working on the unit.
1.6 Declaration of conformity
1.3 Identifying the equipment
A legible and indelible data plate listing the specifications
of the unit is affixed in a visible location on the unit.
The information on the plate
(particularly the description
and the serial number)
must be quoted in all correspon-
dence.
