EN
EN
Testing mode (default setting):
The detector detects once every
10 seconds.
Power saving mode:
The detector enters a 5-minute testing mode
firstly, and then switches to power saving mode. If the detector
detects movements twice in 5 minutes, it automatically goes into
asleep state. If there is no movement detected in next 5 minutes, it
will switch from asleep state to arm. As long as there is a movement
detected within 5 minutes, the duration of power saving mode will
be extended.
Note:
It is suggested to set the detector in power saving mode for daily use to save power.
Test
Remove the battery activation strip. After red and orange LED
flash continuously for 1 min, it enters working state. By then, put
the detector on a shelf, walks from the left to right (or right to left)
within the detection scope to trigger it, red and orange LEDs will
flash once. This indicates the detector is working properly.
Installation & Notices
Installation steps:
1. Make the attachment bracket and base apart.
2. Fix the base on the right place (see notices).
3. Tighten the attachment bracket with the detector.
4. Tighten the attachment bracket with the base and adjust to proper
detecting angle.
Notices:
1. It is recommended to mount the detector at height of 2 m from the
ground.
2. The detector is more sensitive to cross movement than vertical
movement, so it is suggested to mount it facing vertical to the
walking direction of people.
3. Please avoid putting big objects in front of the detector which will
influence the detection.
4. Please avoid any cases that pets can climb over to avoid false
alarms.
5. As it is a solar-powered detector, please install it where adequate
sunlight is ensured.
