12
Directed Digital Solutions CHRYSLER13
© 2016-07-12 Directed. All rights reserved.
Module programming
Refer to "LED diagnostics and troubleshooting" on page 13 for more information and for troubleshooting purposes.
To connect the module:
1
Please
ensure
that the vehicle is in a safe location and cannot move forward during
programming. For vehicles equipped with a manual transmission, make sure the gearshift
lever is in the neutral position.
2
Connect
all the harnesses to the Directed Digital Solutions,
EXCEPT
the 12-pin main power
harness.
Connect all but the
12-pin harness
Note:
The firmware does not control the OEM alarm. Remove the battery in the OEM
remote to prevent the vehicle from arming. To skip the transponder programming and use
convenience features only, press the programming button five (5) times.
REMOVE
BATTERY
CR 2032
3V
3
Connect
the 12-pin main power harness, and wait until the LED turns ON solid red.
Note:
To skip bypass, press the programming button five (5) times.
Must be connected LAST
&
Solid
4
Turn
the key to turn ignition ON then back OFF. Repeat until the LED starts to
flash orange slowly. It may take up to ten (10) times.
Note:
If transponder programming was skipped, the LED turns ON solid orange
for 3 seconds then shuts OFF.
START
Key OUT
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
START
Key OUT
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
&
Flashes
orange
slowly
&
5
Turn
vehicle ignition OFF and proceed to the next step.
START
Key OUT
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
6
Remove
the module from the vehicle and
reconnect
it to your computer. The Directechs
web site will automatically recognize that you are moving onto the second phase of the
programming sequence.
7
Select
the method and click on
Submit Key2Go Request
.
8
Once the configuration is completed,
reconnect
the module. The LED turns solid green for 3
sec. then OFF.
&
Off
Solid
x3 secs
9
Pair
remotes (if applicable). For information on how to pair a specific remote, please
refer to its corresponding owner documentation, which can be found inside the product
packaging of the complete system or on www.directechs.com.*
Pair
remotes*
10
By default, the tachometer is preprogrammed for the vehicle. For instructions on how to
program tach, see page 16.
Initialize
tachometer
* Your aftermarket remote may differ from the model shown in the illustrations.
You have successfully completed the module programming sequence.
