Figure 3: AC & Emergency Power Wiring
CAUTION:
Provide conduit/armored connection for each Data Output Cable. (Min 20MSG metal plate)
Data/DMX Connection
To connect the wiring of the control data cables: (Figure 2 & 4)
1. Remove the data output cover plate using #1 Phillips screwdriver
2. Pull and remove the plastic covers of the data cord output holes (Port 1, 2, 3)
3. Insert the data cable for each port through the data cord output hole with the appropriate
cable strain relief corresponding/adjacent to each Terminal Plug location
4. Unplug each Terminal Block Plug from the Header
5. Connect the wiring for each of the data cable into the Terminal Block Plug using Ø 1.8mm
slotted screwdriver
6. Pull back on the wire to be sure it is secure and check there are no wire strands outside the
terminal block
7. Plug the wired data output Terminal Block Plug into the Terminal Block Header
8. Fasten the cable strain reliefs of each data cable using #1 Phillips screwdriver
9. Put back and fasten the cover plate
Figure 4: Data Output Wiring
Note: In SINGLE PHASE,
connect to LIVE 1 with
JUMPERS to LIVE 2 and
LIVE 3
