Magic Box EtherSwitch 7 User Manual
5
V1.1 September 2012
www.chroma-q.com
Front Panel: 2 Ethercon Ports
Rear Panel: 5 Ethercon Ports, 1 OpticalCon Fibre Optic
Port
2.4
LED Indicators
1.
The LED indicator for power at the front panel will light up (Green) when the EtherSwitch 7F is receiving power,
otherwise, it is off.
2.
Cable diagnostic will start upon power up, which will determine if the Ethernet cables connected support 1000Mbps
and a successful link is present. This process is indicated by the
Speed
LED corresponding to each of the 8 ports
blinking (Green) sequentially.
The initial port scan takes about 10 seconds. A detected cable fault or no link present will be indicated by the
corresponding port’s
Speed
LED glowing (Amber) for 5 seconds after the initial port scan.
A good cable connection will be indicated by the corresponding port’s
Speed
LED glowing (Green) for 5 seconds.
The EtherSwitch 7F will then reset for normal operation.
3.
The
Speed
LED indicators (Top) at the front panel that corresponds to each port number will light up (Green) when a
secure connection is present.
The
Activity
LED (Bottom) will light up steady with a successful link and blink when reception or transmission of data
is occurring at the port.
4.
The
Speed
LED indicator will light up green when the port is connected to a 1000Mbps Ethernet station, and amber
when connected to a 100Mbps Ethernet device. The indicator will remain off when the port is connected to a
10Mbps Ethernet device.
F
Activity LED Indicators
Speed LED Indicators
POWER
3
4
5
2
1
7
6
