21
Step 3:
Installation of the footrest holder (45) with connecting tubes (7).
1. Push the axle (26) into the middle position at handlebar support (3) and
put one wave washer (5) and the connecting tube right (7R) onto the
right axles’ end (26). Put on the screw (6) a spring washer (12) and a
big washer 8//32 (10) and tighten it firmly.
(Note:
Right is specified as
viewed standing on the machine during training.)
2. Install the left connection tube (7R) incl. all additionally required parts
on the left hand side of the machine as described in 1.
3. Push the footrest holder (45R) at the connecting tube (7R) and adjust
the holes in the tubes so that they are aligned.
4. Push the axle bolt (50) through the holes and tighten the footrest holder
(45R) at connection tube (7R) with washers (14), spring washers (12) and
screw (6) firmly. (This connection point has to move easily. So please
don’t tighten the screw too much.)
5. Install the left footrest holder (45L) incl. all additionally required parts
on the left hand side of the machine as described in 3. – 4.
6. Mount plastic cover set (44+46) to front side of footrest holder (45L+45R)
and secure with screws (31+90) for each side.
Step 4:
Installation of the handgrip (41) at connecting tubes (7).
1. Push the handgrip bars (41L+41R) onto the connecting tubes (7L+7R)
and adjust the holes in the tubes so that they are aligned.
(Note:
the handgrip bars must be aligned after assembly so that the
upper ends are inclined outwards (away from the support (3)).
2. Push the bolt M8x40 (39) through the holes and tighten the handgrip
bars (41) with curved washers (13) and distance ring (40) at connection
tubes (7L+7R) firmly.
English