Christopeit Sport 2092, Инструкция по сборке и использованию

Страница: 18 / 32

18
GB
ASSEMBLY INSTRUCTIONS
Remove all the separate parts from the packaging, lay
them on the floor and check that all are there on the
basis of the assembling steps. Please note that a num -
ber of parts have been connected directly to the main
frame and preassembled. In addition, there are seve -
ral other individual parts that have been attached to
separate units. This will make it easier and quicker for
you to assemble the equipment. Assembly time ap -
prox. 60min.
STEP 1:
Attach the stabilizer (45+55) at main frame (40).
1.
Attach the front foot (45) with preassembled trans -
portation roller (44+46) to the main frame (40).
Do this with the two screws M8x55 (41), washers
8//16 (28) and self-locking nuts M8 (43).
2.
Attach the rear foot (55) with preassembled height
adjustable screw (57) to the main frame (40). Do
this with the two screws (41), washers (28) and self
locking nuts (43). After assembly has been completed,
you can compensate for minor irregularities in the
floor by turning the foot screw (57). The equipment
should be set up that the equipment does not move
of its own accord during a training session.
STEP 2:
Connection of cables (2+39) and assembly of sup -
port (8) at the main frame (40).
1.
Place screws M8x16 (32), washers 8//16 (28), cur -
ved washers 8//19 (33) and spring washers for M8
(27) accessibly beside the front part of the main
frame (40).
2. Place the lower end of the support (8) against the
main frame (40) and plug the ends of the two com -
puter cable harnesses (2+39) projecting from (8+40)
together. (Note: The computer cable harness (2)
projecting from the support (8) must not slide into
the tube, as it is required for later steps of installa -
tion.) When joining the tubes, ensure that the cable
connection will not trapped.
3. Put one spring washer (27) and one washer (28)
or curved washer (33) on each screw (32). Push the
screws (32) through the holes in the support (8),
screw into the threaded holes of the main frame (40)
and tighten firmly.
STEP 3:
Installation of the footrest holder (100+103) at pedal
crank (91).
1.
Put the left footrest holder (103) at the pedal crank
(91) on left hand side and tighten the footrest holder
(103) with washers 8//22 (14), spring washer for M8
(27) and screw M8x20 (99) firmly. Put the screw cover
(98) onto the footrest holder (103).
2. Push the connection tube cover (31) onto left con
-
nection tube (34) into intended position and tighten
with screws M5x12 (5).
3. Install the right footrest holder (100) incl. all
additionally required parts on the right hand side of
the machine as described in 1. – 2.