Serial Commands
Christie MicroTiles Serial Commands Technical Reference
15
020-101547-01 Rev. 1 (03-2015)
Commands
Command
Description
Values
NET+DOMA
Sets the domain name
-
NET+ETH0
Sets the IP address for the first
ethernet controller.
-
NET+GATE
Sets the network gateway.
-
NET+HOST
Sets the host name.
-
NET+MAC0
Gets the MAC address of the first
ethernet controller.
-
NET+PORT
Sets the PORT number.
-
NET+SUB0
Sets the network subnet mask for the
first ethernet controller.
-
NET <ip> <subnet> [gateway]
Sets the projector network settings as
specified.
All three arguments are strings and
the gateway is optional.
NET+DGRP <group>
Sets the device group name for the
projector.
This can help simplify broadcast
searching by organizing projectors
into groups, particularly if a large
number of projectors are on the same
local network.
-
NET+DHCP 1
Enables DHCP. To turn off DHCP
support, switch to a static IP by using
the base command.
-
NET+ETH0?
Returns the projector IP address.
(Read-only)
-
NET+GATE?
Returns the projector gateway
address. (Read-only)
-
NET+HOST <name>
Sets the name for the projector.
With this set, devices on the same
network subnet as the projector can
connect to it using the name:
<name>.local.
-
NET+MAC0?
Returns the MAC address of the
Ethernet port. (Read-only)
-
NET+PORT?
Returns the TCP port used for the
Christie Serial Protocol over Ethernet.
(Read-only)
1024 to 49151
(with some exceptions)
3003 = Reserved on the projector and
cannot be used for the Christie Serial
Protocol
NET+SUB0?
Returns the projector netmask.
(Read-only)
-
