Christie MIRAGE DS+8K-J, Руководство пользователя

Страница: 13 / 26

Section 3: Operation
Mirage J Series User Manual 2-5
020-100708-01 Rev. 1 (11-2011)
3D Mode: Select the mode of your 3D operation.
Off : 3D operation is disabled.
Auto 3D : Attempts to automatically determine which 3D mode to use based on auxiliary video data, e.g.
HDMI info frame.
Native 3D : All content is shown at a native frame rate of 96 - 120 Hz input and output.
Frame Doubled 3D : 3D Content from a single 48-60Hz signal (24/30Hz per eye) is displayed twice to
provide a 3D content to be viewed at 96-120Hz.
Dual Input 3D : Content from two independent 48-60Hz ‘passive’ frame locked sources are interleaved
into a native 96-120Hz native frame rate. This requires and optional input module and both signals must be
from the same signal type.
Side-by-Side 3D : Content is transmitted with each eye beside each other in a single frame, and is extracted
and scaled appropriately to show in an alternate-frame sequence. Typically used for broadcast 3D-TV.
Top-and-Bottom 3D : Content is transmitted with each eye above one another in a single frame at half
resolution, and is extracted and scaled to show in an alternate-frame sequence.
Frame Packed 3D : Content is transmitted with each eye at full resolution in a double-sized frame, and is
extracted to show in an alternate-frame sequence. Typically used for Blu-ray 3D movies and 3D video
gaming.
Triple-Flash 3D : 3D Content from a single 48Hz signal (24Hz per eye) is displayed three times to provide
you a 3D image to be viewed at 144Hz.
Dark Interval : Artificially increases the amount of dark time between displayed frames for stereoscopic 3D
images. Higher settings provide more time for shutters in 3D glasses to open and close, ensuring that each eye
sees the full display intended for it. Symptoms of cross talk or color artifacts can indicate the need for
adjustment. The Dark Interval range of adjustment depends on the vertical frequency of your source-the higher
the frequency, the smaller the range. Default setting is 2.3ms.
3D Sync Input : The 3D sync signal is generated by the 3D source to insure left/right eye content is
synchronized to the projector and you. The projector has the ability to physically connect to two different
sources. Ensure that the correct 3D sync input is selected (either Input A or Input B) with each 3D signal
source. If none/internal is selected the projector will generate the sync internally and content will be displayed;
however, there is a 50% chance that the content will be displayed with the left/right eyes swapped (from the
remote, press
FUNC
6-9 to swap the eyes).
NOTE:
This function is not used in Interleaved 3D mode. Each eye
receives a selected input and no 3D sync input is required.
Downloaded From projector-manual.com Christie Manuals