WARNING TEMP. INDICATOR
WARNING TEMP. Indicator flashes red and projector is automatically turned off when an internal temperature of the
projector exceeds normal temperature. Wait at least 5 minutes before turning on projector again.
When WARNING TEMP. Indicator continues to flash, check the items listed below.
Ventilation Slots of the projector may be blocked. In such an event, reposition the projector so that Ventilation Slots
are not obstructed.
AIR FILTER CARE AND CLEANING
Air Filter may be clogged with dust particles. Clean Air Filter by following the section AIR FILTER CARE AND
CLEANING below.
1
2
If WARNING TEMP. Indicator remains on after performing the above checks, Cooling Fans or the Internal Circuits may
be malfunctioning. Contact service personnel from an authorized dealer or a service station.
3
AIR FILTER
S
Pull up and remove
for cleaning every 250 hours
.
Turn off the projector, and disconnect AC power cord from the
AC outlet.
1
2
Removable Air Filters prevent dust from accumulating on the surface of Projection Lens and Projection Mirror. Should Air
Filters become clogged with dust particles, it will reduce Cooling Fans’ effectiveness and may result in internal heat build up
and adversely affect the life of the projector. Clean Air Filters
every 250 hours of operation,
following the steps below:
Clean Air Filters with a brush or wash out dust and particles
, or install new.
3
Replace three Air Filters properly. Make sure that Air Filters are
fully inserted.
4
CAUTION
Do not operate the projector with Air Filter removed. Dust
may accumulate on LCD Panel and Projection Mirror
degrading picture quality.
Do not put small parts into Air Intake Vents. It may result in
malfunction of the projector.
RECOMMENDATION
Aoid operation the projector in
dusty/smoky environments.
Operation
in
such
environments
may cause poor image quality.
When using under dusty or smoky conditions, dust may accumulate on a lens, liquid crystal panels, or optical elements
inside the projector. This condition may degrade the quality of a projected image.
When the above symptoms are noticed, contact your authorized dealer or service
station
for proper cleaning.
3
New filters are included in the Lamp/Filter Kit (P/N 03-000712-01P). Single filters are also available separately:
> 003-000843-01 Base Filter A
> 10-A6103015095 Base Filter B
> 003-000844-01 Base Filter C (LX34 Only)
> 003-000842-01 Base Filter, Lamp
013-100237-02 Rev. 1 (02/07)
Air filters
This filter is on the
LX34 Model ONLY.
Turn the projector upside down and remove Air Filters by
pulling the latches upward.
Содержание LX32
Страница 1: ...013 100237 02 Rev 1 02 07 ...
