FHD462-X LCD Panel User Manual
15
020-000769-02 Rev. 1 (01-2016)
Installation
Remote Control
To install batteries in the remote control:
1. Press down the tab on the cover and pull the cover up.
2. Insert the included batteries. Ensure that the polarities correctly match the
and
markings
inside the battery compartment.
3. Insert the lower tab of the cover into the opening, and press down the cover until it clicks in
place.
Notes on Batteries
• Make sure that the battery polarities are correct when installing the batteries.
• Do not mix an old battery with a new one or different types of batteries.
• If you will not use the remote control for a long time, remove the batteries to avoid damage
from battery leakage.
• Do not expose batteries to excessive heat such as from sunshine, fire or the like.
Notes on Remote Control Operation
• Make sure that there is nothing obstructing the infrared beam between the remote control and
the IR receiver on the display.
• If the effective range of the remote control decreases, or it stops working, replace the batteries
with new ones.
• The remote control may fail to operate if the infrared remote sensor is exposed to bright
sunlight or fluorescent lighting.
• Ambient conditions may possibly impede the operation of the remote control. If this happens,
point the remote control at the display, and repeat the operation.
Notice. Failure to comply with the following may result in property damage.
• Installation must be performed by a qualified custom video installation specialist.
