Configuring light settings
Inspire Series User Manual
48
020-001934-01 Rev. 1 (11-2021)
Copyright ©2021 Christie Digital Systems USA Inc. All rights reserved.
Adjusting WLAN setting
Set up network configuration for wireless networking.
1. Select
Menu
>
Configuration
>
Communications
>
WLAN
.
2. Set up the appropriate setting:
•
SSID
—Display the SSID of the wireless network.
•
Enable
—Enable or disable the wireless functionality.
•
Start IP
—Assign the start IP address of the wireless network.
•
End IP
—Assign the end IP address of the wireless network.
•
Subnet Mask
—Assign the subnet mask of the wireless.
•
Default Gateway
—Assign the gateway of the wireless.
3. To apply the WLAN settings, select
Apply
.
Adjusting network setting
Set up network configuration setting, such as reset back to default.
1. Select
Menu
>
Configuration
>
Communications
>
Network
.
2. Set up the appropriate network setting:
•
Projector Name
—Display the name of the projector. User can change the name of the
projector by web user interface.
•
Show Network Message
—Enable or disable to display of the network message.
•
Reset to Default
—Reset the network configuration setting, including LAN setting and
• WLAN setting, back to default.
3. To apply the network configuration, press
ENTER
.
Setting serial port baud rate
Select the serial port and baud rate.
1. Select
Menu
>
Configuration
>
Communications
>
Serial Port Baud rate
.
2. Set up the appropriate baud rate.
3. To confirm the selection, press
ENTER
.
Enabling serial port echo
Enable or disable to allow the CLI command pass through.
1. Select
Menu
>
Configuration
>
Communications
>
Serial Port Echo
.
2. To swap, press
ENTER
.
