Installation
DWU6322-GS/DWU7062-GS User Manual
28
020-001792-01 Rev. 1 (04-2020)
Copyright ©2020 Christie Digital Systems USA Inc. All rights reserved.
Removing and installing the lens
When handling the projector after lens installation, make sure the front lens cap is placed on the
lens to protect the lens surface from potential damage. When carrying or moving the projector, do
not handle by the lens. This may damage the lens, the chassis, or other mechanical parts within the
projector.
1. Center the lens. Ensure the lens is at or near its center position. Attempting to remove the lens
with a large offset may cause damage to the lens assembly.
Center the lens while the projector is switched on by pressing the
Lens Horizontal
or
Lens
Vertical
button and then pressing
Enter
.
2. Turn off the projector.
3. Allow the projector to cool down into standby mode before replacing the lens.
4. After the projector has cooled down and prior to replacing the lens, remove the power cord.
5. To remove the lens, remove the lens ring cover first. Then press the
Lens Release
button
with a tool and rotate the lens counterclockwise by a quarter to release the lock.
Remove the lens through the front of the projector.
6. To install the new lens, fully insert the lens assembly straight into the lens mount without
turning. Rotate the lens cap clockwise to lock the lens in place.
Warning!
Failure to comply with the following could result in death or serious injury.
• Turn off the projector and remove the power cord, before installing or replacing a lens.
A
B
A
B
Содержание DWU6322-GS
Страница 1: ...Christie GS Series DWU6322 GS DWU7062 GS User Manual 020 001792 01...
Страница 84: ......