Installation and setup
HS series 2K Installation and Setup Guide
31
020-002038-01 Rev. 1 (09-2022)
Copyright ©2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Setting up the projector lens
Set up the projector lens to adjust the image size, focus, and position.
Adjusting the zoom and focus
Ensure that the image reflected from the digital micromirror device (DMD) is parallel and centered
with the lens and screen.
1. Display an image or test pattern that can be used to analyze image focus and geometry.
2. Press
ZOOM
on keypad or remote control.
You can also select
MENU
>
Configuration
>
Lens Settings
>
Zoom
.
3. Use the up and down arrow keys to zoom in or out of the image.
4. To exit the menu, press
EXIT
.
5. Press
FOCUS
on keypad or remote control.
You can also select
MENU
>
Configuration
>
Lens Settings
>
Focus
.
6. Use the up and down arrow keys to adjust the focus of the image.
7. To exit the menu, press
EXIT
.
8. To refine your adjusts, repeat steps 2 to 7.
Adjusting lens position
Shift the lens to the specific position.
1. Display an image or test pattern that can be used to analyze image location.
2. Press
LENS
on keypad or
LENS H/LENS V
on remote control.
You can also select
MENU
>
Configuration
>
Lens Settings
>
Lens Shift
.
3. Use the arrow keys to adjust the lens position.
For best lens performance, keep the shift values within the lens offset ranges. See
on page 32 for more information.
4. To exit the menu, press
EXIT
.
Resetting the lens to home position
Set the lens offset back to the home position.
1. Press
LENS
on keypad or
LENS H/LENS V
on remote control.
You can also select
MENU
>
Configuration
>
Lens Settings
>
Lens Calibration
.
2. Press
ENTER
.
3. To start the lens calibration, select
OK
.
