Installation and setup
HS series 2K Installation and Setup Guide
25
020-002038-01 Rev. 1 (09-2022)
Copyright ©2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
• Damage to the projector.
Calibrate the lens motors when any of the following conditions are met:
• After a lens change.
• After the projector is moved.
• After any manual adjustment made to the zoom or focus.
To calibrate the lens motor:
1. Press
LENS
on keypad or
LENS H/LENS V
on remote control.
You can also select
Menu
>
Configuration
>
Lens Settings
>
Lens Calibration
.
2. Press
ENTER
.
3. To start the lens calibration, select
OK
.
Removing the projection lens
To safely remove the projection lens, complete the following steps.
1. Center the lens while the projector is switched on by pressing the
LENS H
or
LENS V
button
and then pressing
ENTER
.
Ensure the lens is at or near its center position. Attempting to remove the lens with a large
offset may cause damage to the lens assembly.
2. Turn off the projector.
3. Allow the projector to cool down into standby mode before replacing the lens.
4. After the projector has cooled down and prior to replacing the lens, remove the power cord.
5. Push in and hold the lens release button.
6. Turn the lens counterclockwise by a quarter to release the lens.
7. Gently pull the lens out of the lens holder.
Notice.
If not avoided, the following may result in equipment or property damage.
• Always use a lens plug when installing or moving the product. This prevents contaminants
from entering the product.
• Do not operate the product without a lens installed.
