Introduction
D4K2560 Setup Guide
7
020-101171-04 Rev. 1 (01-2015)
Installation safety and warning guidelines
AC/power precautions
To correctly install this projector, a certified electrician must install a permanent three-phase
connection to the lamp power supply (LPS). The LPS projector outlet is used to supply power to the
projector head. Operate the projector at the recommended voltage.
Danger!
Failure to comply with the following results in death or serious injury.
• This product must be installed within a restricted access location which is normally inaccessible by
the general public, including workers, visitors, and residents in the immediate vicinity, by means of
engineering or administrative control measures but is accessible to authorized personnel that may
not have specific safety training.
• This product must be located and positioned in a way as to restrict audience members from direct
access to enter the light beam path.
• Do not install the projector overhead.
• When installing the projector in portrait mode, the device holding the projector must have a weight
rating sufficient to hold the weight of the projector. The projector weighs 125kg (275 lbs).
• The projector uses a high-pressure lamp that may explode if improperly handled. Always wear
manufacturer approved protective safety clothing (gloves, jacket, face shield) when the lamp door
is open or when handling the lamp. Failure to comply results in death or serious injury.
Warning!
Failure to comply with the following could result in death or serious injury.
• A qualified technician is required for all installations.
• SHOCK HAZARD. Never operate the projector without all of its covers in place.
• Use of the projector’s rear safety strap is
mandatory
to prevent the projector from tipping.
Secure the strap between the projector and the surface it is mounted to.
• Four or more people are required to safely lift and hand-carry one projection head a short distance.
Christie recommends removing the lamp before transporting the projector.
• Two or more people are required to safely lift and hand-carry the lamp power supply (LPS).
Notice.
Failure to comply with the following may result in property damage.
• Perform an automatic LampLOC adjustment when the lamp is moved, leveled, or a new lamp is
installed in the projector.
• Keep the projector level when lifting or transporting. Avoid tilting the projector to the right. This
can introduce an air bubble into the coolant hoses that can result in an air lock and the overheating
of the projector.
Danger!
Failure to comply with the following results in death or serious injury.
Disconnect projector from AC before opening any enclosure.
Warning!
Failure to comply with the following could result in death or serious injury.
• Verify that the projector is using a line cord, socket, and power plug that meets the appropriate
local rating standards. Use only an AC power cord recommended by Christie. Do not attempt
operation if the AC supply and cord are not within the specified voltage and power range.
• Do
not
allow anything to rest on the power cord. Locate the projector where the cord cannot be
abused by persons walking on it or objects rolling over it. Never operate the projector if the power
cable appears damaged in any way.
• Do
not
overload power outlets and extension cords as this can result in fire or shock hazards.
Содержание D4K2560
Страница 1: ...D4K2560 S e t u p G u i d e 020 101171 04...