Christie CP2309-RGB, Инструкция по установке и настройке

Страница: 21 / 44

3. Position the lens so the lens retaining ring mounts align with the lens mount.
4. Remove the lens caps from the front and rear of the lens.
Lens caps must be removed or they can melt and damage the lens.
5. Insert the lens straight into the lens mount opening without turning.
Magnets inside the lens mount help position the lens.
6. Lock the lens assembly in place with a hex key.
7. Replace the lens surround.
Removing the projection lens
Use the correct method of removing the lens.
1. For motorized lens mounts only, disconnect the lens zoom motor from the two zoom motor
harness connectors.
2. Turn the clamp on the lens mount to unlock the projection lens.
3. Slide the lens straight out of the projector.
If the lens does not slide out easily, reset the lens offset.
4. Attach the lens cap to avoid damage to the lens.
Installing and setting up
CP2309-RGB Installation and Setup Guide 21
020-103078-01 Rev. 1 (06-2019)
Copyright
©
2019 Christie Digital Systems USA, Inc. All rights reserved.