CP2000-M/MR Ballast Replacement Instruction Sheet
1 of 5
020-100511-01 Rev. 1 (05-2010)
CP2000-M/MR Ballast Replacement
Instruction Sheet
INTRODUCTION
Use the following instructions when replacing the ballast in CP2000-M/MR (119-001101-xx/119-
002103-xx) projectors. The entire procedure takes approximately 20 minutes to complete.
SAFETY AND WARNING GUIDELINES
HIGH VOLTAGES MAY BE EXPOSED! Always power down and
disconnect power sources prior to servicing. Once the projector is powered down, allow
the cooling fans to automatically turn OFF before disconnecting from AC and opening
the projector. Depending on your projector model this can take 10-15 minutes.
QUALIFIED SERVICE TECHNICIANS REQUIRED! All module replacement
procedures must be performed by qualified service technicians.
NON-INSULATED DANGEROUS VOLTAGES MAY BE EXPOSED! Always
disconnect from AC prior to disassembly.
OBSERVE ALL ELECTROSTATIC PRECAUTIONS! Use a grounded wrist
strap when handling electronic assemblies.
Never operate the projector (or the fans) without all the covers installed.
KIT REQUIRED
#003-120476-01 CP2000-M/MR Ballast Replacement Service Kit
TOOLS REQUIRED
• Phillips
™
#1 (long stem), #2
• 10mm wrench (to loosen ground nut)
