6. To install the replacement part, follow these steps in reverse order.
7. Upload the configuration to the new receiver card.
a) Log into the E500 software and select Screen Configuration.
b) Select Configure Screen and click Next.
c) On the Receiving Card tab, select a working receiver card and click Read from Receiver
Card.
d) Click Send to Receiver Card.
8. Calibrate the receiving card as if new modules have been installed.
Related information
Calibrating replacement LED modules
Replacing the hub board
The hub board connects the LED modules with the receiver card.
1. Remove the LED modules (on page 8).
2. Remove the carrier assembly (on page 8).
3. Place the carrier assembly face down on a protected surface.
4. Remove the receiver cards (on page 10).
5. Label and remove all cable connections from the hub board.
6. Loosen the thumbscrews securing the hub board to the carrier assembly (A).
Parts and module replacement
Velvet LED Display Panels Service Guide–Apex Series
11
020-102617-01 Rev. 1 (01-2018)
Copyright
©
2018 Christie Digital Systems USA Inc. All rights reserved.