Base Box Assembly
Page 8
Installation Manual
5.
Loosely install the hinge pin screws, flat washer and conical spacer to each side of the base box.
6.
Slide the conical spacer and the flat washer to the back of the screws.
7.
Raise the 38-817001-01 mounting bracket and attach to the projector’s chassis and insert the hinge-
pins through the hinge-pin openings. (See the 38-817001-01 Installation sheet on how to hold the
mounting bracket to the projector.)
8.
Raise the rear of the projector and install the four (4) M6 x 12 mm angle locking screws to the rear of
the base box. Adjust the angle and lock it.
9.
Tighten the two (2) M6 x 12 mm hinge pin screws (Figure 2).
CAUTION
:
Do not over tighten the screws.
Figure 2
. Projector Mount
NOTE
: Make the final tilt and roll adjustments at this time
.