Christie 1000W J Series, Руководство по установке

Страница: 36 / 58

4-4 J Series 1000W & 1200W Setup Guide
020-100740-02 Rev. 1 (03-2014)
Section 4: Maintenance
8. LOCK IN THE NEW LAMP MODULE
Pull out and turn the lamp lock lever 1/4 turn clockwise to “lock” the lamp in place. NOTE: If you are unable to
turn the lamp lock into position, repeat step 6 to ensure the lamp is making full contact with the terminal block.
9. REPLACE THE LAMP DOOR
Replace the lamp door and secure it with the two (2) screws removed in step 2.
IMPORTANT:
The lamp module is calibrated for maximum performance and brightness. Do not attempt to re-
align or adjust the lamp module.
10. In the lamp menu, select CHANGE LAMP . This will prompt for the old lamp serial number (if it was not
previously entered). Enter the new lamp serial number. NOTE: This action is not mandatory, it is
recommended for accurate lamp statistics to be archived.
Filter Replacement Procedure
Only use Christie approved filters. See Table 5.1.
The filter located at the front side of the projector and should be replaced whenever the lamp is replaced. If you
are working in an extremely dusty environment you may want to replace the filter sooner. If this filter is not
replaced, airflow may become restricted and cause the projector to overheat.Use the filter provided in the
Christie approved Lamp and Filter Kit for your specific projector model. See Table 5.1.
1. TURN OFF THE PROJECTOR, COOL AND UNPLUG
Before removing or installing a filter, turn off the projector and allow it to cool for 5 minutes before
unplugging.
2. REMOVE FILTER DOOR
Loosen the 2 lock screws at the top of the filter door. Lift the door away from the projector. See Figure 4-5 .
F
IGURE
4-5
3. REPLACE FILTER
Remove the old filter and insert the new one.
4. RE-INSTALL THE FILTER DOOR
Secure the lock screws.
WARNING