2-4
J Series 1000W & 1200W Setup Guide
020-100740-02 Rev. 1 (03-2014)
Section 2: Installation and Setup
•
Video Decoder Input Card
: depending on the source you can apply the following;
• Composite video source to 1-CVBS, using a BNC Cable
NOTE:
Same signal can be used on 4, 5 or 6 when
input is selected as CVBS.
• A component signal on Inputs 4(Pr), 5(Y), 6(Pb) using BNC Connectors.
NOTE:
Grouped as a component
input, YPbPr
.
• S-Video to one of the two, 2-SVID or 3-SVID using S-Video cable.
• S-Video using two BNC cables, with Luma (Y) connected to 4 (Sy) and Chroma (C) connected to 6 (Sc).
NOTE:
Must be grouped as 1 S-Video + 1 CVBS.
• Component input grouping is selected in the menu.
•
DMX512 Interface Card
: has two 5pin XLR connectors - 1 (input) male and 1 (output) female. If there is
active communications on the DMX512 Interface card the power LED will blink between low intensity and
high intensity.
•
Twin DisplayPort Input Card:
Accepts DisplayPort 1.1a inputs from one or two DisplayPort sources.
STEP 4 - Connecting the Line Cord
IMPORTANT!
Use the line cord provided with the projector.
NOTE:
Voltage and current requirements are
listed on the license label, located at the back of the projector.
Connect the projector's line cord to the AC receptacle at the AC inlet of the projector. Plug the 3-pronged plug
end into a suitably rated grounded AC receptacle.
Do not attempt operation if the AC supply and cord is not within the specified ratings. On
power down, wait 5 minutes for the fans to turn OFF before unplugging the projector.
STEP 5 - Power up
After the AC Power has been switched on, the LCD display above the keypad indicates “Please wait” and the 4
LED status indicators at the rear of the projector will be solid amber.
The projector has reached standby and is ready for use when:
• The LCD displays “Standby mode”
• The Status LED is solid amber
• The Lamp LED is off
To turn on the projector, do one of the following:
• Press and hold the power button on either the built-in keypad or the remote control
• Press the power button twice (quickly) on either the built-in keypad or the remote control
Thereafter; the lamp and fans will power on and a green LED will start scrolling back and forth indicating that
the projector is in warm up mode.
The projector is on and ready to display video when the lamp LED and the status LED are both solid green.
NOTE:
See
Section 3 Operation
for a full description of the status indicators
.
NOTE:
If the projector has a stepper motor lens mount installed and the inserted lens has never been
calibrated, there will be a short period where the projector calibrates all of the lens motors (zoom, focus,
horizontal, and vertical) by moving them through their full range of motion.
WARNING
Содержание 1000W J Series
