Door Assembly/Installation
48" and 52" HyfloTM Fans Installation and Operators Instruction Manual
4
MV1747D
To install the Door in the Cone you must first identify the top of the Cone and the top of the Door. The
bottom of the Cone Has a C-shaped cut-out in it that will later be used for a drainage knockout
(See Figure
8)
. The top of the Door can be identified by the location of the Door Springs. The Spring attaches to the Post
towards the top of the Door
(See Figure 8).
With the Door opening towards the ground,
as shown below
,
line up the Four Holes in the Door Ring with the
second set
of holes from the edge of the Cone and thread
(4) 5/16 x 1.25" Bolts in until they are tight. Do not install Nuts at this time. These Bolts will be used later
to attach the Cone Brackets.
Use (2) 5/16 x 1.25" Bolts
and 5/16 Flange Nuts to attach the Ring to the Cone using the Holes located on
both sides near the Door Center Brace as
shown below
.
Note that the Nuts go on the outside of the Cone
.
Turn the Cone over to install the Grill. Orient the Grill so the Leg with the bent spokes at the Center of the
Grill is Parallel with the Center Door Hinge and that the bent Spokes are either above or below center.
Not
to the left or right
.
(See Figure 10)
. Install the Rubber Grommet 3/4" to 1" from the end of the bent Spokes.
Fasten the Grill on with (8) 5/16 x 1/2" Carriage Bolts and Flange Nuts
as shown below
.
Note that the Nuts
are to the Inside of the Cone
.
Door Assembly/Installation
Top of Cone
C-shaped Knockout
Spring attaches toward
the Top of Post
Post
Top of Door
Second Set of Holes
Figure 8. Installing the Door
from Edge of Cone
Item
Description
1
5/16 x 1/2" Carriage Bolt
2
5/16 Flange Nut
3
Door Center Brace
3
1 3
2
Figure 9. Attaching the Ring to the Cone
3
3
3/4" to 1"
3
2
3
3
Item
Description
1
5/16 x 1/2"
Carriage Bolt
2
5/16 Flange Nut
3
Rubber Grommet
4
Leg with Bent
Spokes
3
1
Figure 10. Attaching the Grill
3
4
Parallel