Test Fan for proper operation.
57" Endura
®
Flush Mount Fan Installation & Operator’s
28
MV2423F
Plug the Fan in and test for proper operation
IMPORTANT!
Disconnect Power Prior To Maintaining Or Cleaning The Fan. The fan may start automatically causing
serious injury or death.
•
Service and repair of fans should be done only by a qualified technician.
•
Minimize contact of moisture or corrosive chemicals to the surfaces of the fan components to maximize fan life.
•
After washing fans, operate fans long enough to remove moisture from all fan surfaces.
•
Keep the fan clean for maximum life and best performance.
Do Not spray water on the Fan Shaft Bearings, the Belt
Tensioner, or the Motor.
•
Periodically check the V-Belt and replace if necessary. A worn Belt will cause a substantial drop in Fan performance or
it can break and cause Fan failure.
If a Belt rides below the Sheave edge, replace the belt.
(See below)
•
Check Belt Tension. The Belt
should be tensioned just tight
enough to minimize Belt slip-
page. Over tensioning the belt
will cause premature Belt and
Bearing wear.
•
The Alignment Mark on the Ten-
sioner Base should be lined up
with the 1st line on the Idler
Support Bracket.
•
Check Sheaves for wear. Replace if a Sheave groove is worn.
Test Fan for proper operation.
Maintenance
Bad Belt
Good Belt
1747-054 04/03
Bad Belt (Needs Replaced)
1st Line
Tensioner Base
Alignment Mark
Tensioner
Idler Support Bracket
Bad Sheave
1747-053 04/03
Bad Sheave (Needs Replaced)
Good Sheave
