8
everyday use
turning on your integrated amplifier
1.
When you plug your amplifier into the mains using the supplied mains lead the power
indicator on the front panel will glow red which means that the amplifier is in standby
mode.
2.
Press the power button beneath the power indicator and after a few seconds it will
glow green indicating that the amplifier is ready for use.
automatic shutdown
1.
If there is a major overload or short circuit the integrated amplifier will detect this and
shut down automatically and the power indicator will fade and switch to red. The
integrated amplifier should then be switched off immediately at the mains.
2.
When the fault has been rectified the integrated amplifier can be switched on and will
power up as usual. You should wait at least two minutes before turning the integrated
amplifier on again at the mains to allow the power supply protection circuitry to reset
itself.
select your input source
Your integrated/pre-amplifier
uses input bus A by default
and the display will read
.
To scroll through the other
input sources press button A.
Press button B to select Bus B.
It is indicated by a dot
displaying between each letter
adjusting the volume
Use the volume knob to adjust the volume manually.
changing the balance
Use the balance knob to shift the balance between the left and right loudspeaker.
Press button A to
Press button B to
select:
select:
.
