18
frequently asked questions
why aren’t any of the remote control buttons working?
Press Pre to set up the remote control for pre-amplifier functions.
I’ve connected all the wires up but I can’t hear any sound?
Ensure that you’ve selected the correct bus (typically Bus A), the correct input
(eg Disc 1) and the correct output (eg Output 1).
why is there no display when I’ve turned the amplifier back on?
You need to wait for two minutes after switching the unit off before switching it on
again.
why is there humming coming from the loudspeakers?
Check that you’ve earthed the unit. The interconnects need to be properly screened
and placed away from mains cables. Interference can be reduced by using balanced
inputs and outputs instead of RCA phono types.
the sound coming from the loudspeakers is distorted
Check that the speakers are connected properly. It may be that the volume is
turned up too loud for your speakers or that you have set the gain for the input
device too high.
the amplifier was in standby mode and has turned itself off
Changing connections while the amplifier is on, for example, dropping the stylus
onto a record can cause the unit to shutdown. Check that the speaker cables have no
stray inner core wires touching each other as this can cause a short circuit.
