Chiron Iris Touch 4 Series, Инструкция по эксплуатации

Страница: 16 / 40

Page 16 of 40 IRIS Touch Engineering Manual Version 1.4
Account Name/Number
Now you are asked to enter the account (name / number) reference allocated by the monitoring centre which can be
alphanumerical and up to 32 characters long, but normally you would expect a 4 or 6 digit numerical account
number.
Press the ‘Set’ button and enter in the account name/number and then click the ‘Save’ button. Now confirm that the
account is entered correctly and press ‘Continue’.
ARC IP Address
Next you will be asked to enter in the ARC (Alarm Receiving Centre) IP address for the monitoring centre. This can be
obtained from the monitoring centre and would normally be the external IP address for their IRIS Secure Apps
system.
Press the ‘Set’ button and enter in the ARC IP address and then click the ‘Save’ button. Now confirm that the IP
address is entered correctly and press ‘Continue’.
Note: Only the primary/main ARC IP address needs be entered on the dialler as all backup or alternative IP
addresses, for the ARC are downloaded to the IRIS Touch dialler on the first polling communications.
Ethernet (IRIS Touch 620NG or 640NG)
Checking Ethernet
The IRIS Touch dialler will now confirm if an Ethernet connection has been made to
another piece of Ethernet equipment like a router or switch, if no connection is being
seen this will display as ‘Ethernet Disconnected’ and the cable between the 2 pieces of
equipment will need to be checked.
If the connection is good you will see ‘Ethernet Connected’ and can press ‘Continue’.
Dialler IP Address
Now you are asked to setup the Dialler IP address for the network to which you are
connecting the IRIS Touch dialler.
By default the IRIS Touch dialler is set for DHCP (Dynamic Host Configuration Protocol) which means that the
network will allocate an IP address and other related settings gateway and subnet. If you are using a DHCP network
connection then press ‘Continue’.
If the customer has requested that a fixed IP address is assigned then press ‘Change’.
You will need to tick the fixed box at the top right and then enter the IP address, subnet
mask and gateway information for the customer network.
Once entered press ‘back’ and confirm the information has been entered correctly then
press ‘Continue’.
The IRIS Touch dialler will then perform a quick check on the validity of the IP address
and confirm if this is ok. If not then please check the IP information entered.