ChiQ WFL8TOL52W, Руководство пользователя, Страница: 10 / 28

Installation
8
Connection the electricity and water
supplies
Connecting the water inlet hose
1. Connect one end of
the water inlet hose
by screwing it to a
cold water tap using a
3/4
gas threaded
connection (see
figure).
Before
performing
the connection, allow
the water to run freely until it is perfectly clear.
2. Connect another
end of the water inlet
hose to the washing
machine by screwing
it
onto the
corresponding water
inlet of the appliance,
which is situated on
the top right-hand
side of the rear part of the appliance (see figure)
3. Make sure that the hose is not folded over or
bent.

The supply water pressure must be in the
0.03—1MPa range, the values indicated in the
Technical date table (
see page 8 ).

If the inlet hose is not long enough, contact a
specialized shop or an authorized technician.

Never use second-hand water inlet hoses.
Use the new water inlet hose supplied with the
machine.
Connecting
the
drain hose
Connect the drain
hose,
without
bending it, to a
draining duct or a
wall drain situated
between
65 and
100cm from the floor;
The drain hose may be
connected to an under
sink
trap. Before
connecting the drain
hose from the machine
ensure that any blanks
or removable ends
have been taken off
the spigot,
If it is placed over the
edge of the basin or
sink be sure the free
end of the hose
should not be under
water tap.