ChiQ WFL8T48W2, Руководство пользователя

Страница: 18 / 28

How to use the appliance
16
Before loading your first load of
laundry
Your new washing machine was tested before
leaving the factory. This process involves running
various wash cycles. As a result, a small amount of
water may remain in the tub and drainage system.
Run a
Drum Clean cycle with no laundry to clean
the system before your first load of laundry.
First add 1 to 2 tablespoons of detergent to the
chamber I. Then run the
Drum Clean cycle.
Wait for the cycle to finish.
Daily use
Preparing the laundry
EMPTY POCKETS
·
Coins, paper clips, etc. could damage the load
and the washing machine components.
·
Tissues will break down during the wash cycle
and the fragments will have to be subsequently
removed by hand.
CLOSE ALL ZIPPERS, BUTTONS, AND HOOKS. TIE
ALL RIBBONS OR BELTS
·
Insert the smaller garments (e.g. nylon hosiery,
belts, etc.) and garments with hooks (e.g.
braziers) into a fabric bag or a pillowcase with
zipper. Remove any rings from curtains, or else
place the curtains inside a fabric bag together
with the rings.
FABRIC TYPE/SYMBOL ON THE WASH LABEL
·
Cottons, mixed fibres, easy care/synthetics, wool,
hand wash items.
·
Color
Separate colored and white items. Wash new
colored articles separate.
·
Size
Wash items of different sizes in the same wash
load, to improve washing efficiency and
distribution of the articles in the drum.
·
Delicates
Wash delicate items separately; they require
gentle treatment.
How to use the washing machine
1. Load laundry
Open the door and load the laundry. Load the
articles one at a time loosely into the drum,
without overfilling. Observe the load sizes given
in the “Table of wash cycle”, Overloading the
machine will result in unsatisfactory washing
results and creased laundry.
2. Close door
Make sure that no laundry gets stuck between
door glass and rubber seal. Close the door so that
you can hear it click shut.
3. Open water tap
Make sure that the washing machine is
connected to the water mains. Open the water
tap.
4. Set the desired program
Select the required program by pressing the
“Program” button.
The duration of the wash
cycle is shown on the display. The washing
machine automatically displays
the default
temperature and spin speed settings possible for
the selected program. Adjust the temperature
and/or spin speed setting if needed with the
relative buttons.
·
Change temperature, if needed
Press the “Temperature” button to progressively
lower the temperature setting until cold wash
has been set (“—“will be shown on the display).
Pressing the button again sets the highest
possible setting.
·
Change spin speed, if needed
Press the “spin” button to progressively decrease
the spin speed until the spin cycle is turned off
(“---” will be shown on the display). Pressing the
button again sets the highest possible setting.
·
Select options, if needed
Press the button to select the option; the
respective symbol on the display illuminates.
Press the button again to cancel the option; the
light extinguishes.