Digital Pumpe-düse Power Chip - Installation Guide
Chiptuning Direct ApS • www.chiptuning-direct.com • [email protected]
Page 5
Unplug the box from the cable lead. In one end of the box there is a transparent lid, remove this.
Adjust the Power Chip by moving the jumper. When delivered the jumper is in position »T«, as il-
lustrated below:
Once the power chip is installed, check the correctness of all connections. Then the engine can be
started. The program can be changed, if necessary. In some cars more powerful programs cause the
exhaust smoke to appear. This is related to the error range of the sensor signals. To eliminate smoke
a weaker program should be set.
In case of problems
If during the installation you are facing any problems or are in doubt you are always welcome to
contact our support department by e-mail at [email protected] (our support can be con-
tacted by E-mail only).
Have fun with your new Digital Pumpe-düse Power Chip in your daily driving!
Best regards
Chiptuning Direct ApS
