Chippmann CS-8 VCF1E, Руководство пользователя, Страница: 12 / 28

CS-8 Series VCF1E Rev1.2, Feb. 2018
-10-
1. Input Controller – attenuates the incoming audio signal at jack 9
between 0 and 1
2. CV-Depth Controller – attenuates the frequency control voltage at
jack
10
between 0 and 1
3. Reso Controller – set the resonance of the filters between 0 and self-
oscillation
4. Freq Controller – set the resonance frequency of the filters between ca. 2
Hz and 40 kHz (0.8 Hz to 100 kHz at mode "Phaser")
5. clip LED – illuminates "red" just before clipping of the audio output stage
6. Reso-Emph 4-pos. rotary switch – determines the strength of the
emphasize of the resonance or the amplitude of the self-oscillation (0.2 =
weak to 0.85 = strong)
7. Gain Controller – set the signal gain from
jack 9
to
jack15
(at position
"10" of Cont.
1)
between -20 db and 0 db
8. Reso-mode 4-pos. rotary switch – selects one of three resonance modes
and switches the filter to the Phaser mode
9. Input jack (input) – routes the applied signal via
Cont. 1
to the filter input
10. CV In jack (input) – routes the applied signal via
Cont. 2
to the frequency
modulation input of the filters
11. 1V/Oct jack (input) – an applied voltage shifts the resonance frequency
of the filter by ± one octave with every ± one Volt input voltage
12. Filter function 12-pos. rotary switch (double assigned)– selects one of 12
different filter functions
13. CV-Res jack (input) – control of the resonance; a voltage of +5 V at this
input corresponds the position "10" of the Cont. 3 , negative input
voltages are allowed
14. 2nd Harm illuminated pushbutton – switch with alternating function
activates a distortion, which adds even-numbered harmonics, especially
to the resonance; "red" inactive, "green" active
15. Out jack (output) – provides the filter output signal
7.2 Back
Fig. 2 shows the back of the module with consecutively numbered elements.