3
Tools needed to complete the assembly:
a screwdriver (not included in the set).
The assembly steps are numbered from 1 to 15. Use their descriptions below along with the illustration
with the same number.
1 – ASSEMBLY OF THE BACKREST TUBE TO THE SIDE BASE TUBES
Note:
Pull out the backrest tube to make sure it is fixed.
2 – ASSEMBLY OF REAR SUPPORT TUBE
Mount the rear support tube to the side base tubes, as shown on the figure.
3 – SCREWS FOR THE REAR SUPPORT TUBE
Insert the screws М5х30, as shown on the figure.
4 – RETAINERS WITH LOCK NUT
Place the retainers with lock nut to the screws inside part of the rear support. Tighten the screws.
5 – ASSEMBLY OF THE FRONT TUBE
Mount the front tube to the side base tubes, as shown on the figure, so the holes match and hold.
Note:
The music box should look forward.
6 and 7– FIXING THE FRONT TUBE
8 – ASSEMBLY OF THE FRONT SUPPORT TUBE
9 and 10 – FABRIC COVER
Place the fabric cover over the backrest tube (fig.9) and around the side tubes (fig.10). Fasten the
buckles to fix.
11 – POSITIONS OF THE SEAT – UPRIGHT AND RECLINED
Press the buttons from both sides simultaneously and adjust.
CAUTION!
FOR NEWBORN BABIES AND LITTLE CHILDREN, WHO CANNOT SIT UNAIDED USE
THE MOST RECLINED POSITION OF THE ROCKER.
12 – ROCKING FUNCTION
Use the rocking function, when the front support tube is folded inside the seat.
Pull out the front support tube, to fix the rocker.
Note:
Make sure the rocker is fixed by pressing the seat downwards.
13 – SAFETY HARNESS
Fasten the two seat belts in the buckles of the soft pad.
IMPORTANT!
After adjusting the length, the belt should be as tight as possible to the child’s body with-
out causing any inconvenience.
ATTENTION!
The belt should not be twisted, worn out or torn.
14 – TOY BAR
CAUTION!
REMOVE THE TOY BAR WITH THE TOYS, WHEN THE CHILD IS ABLE TO SIT UNAIDED!
15 – MUSIC AND VIBRATION BOX
The music and vibration box is mounted and removed from the front tube by sliding.
Batteries:
Remove the cover of the battery compartment with a screwdriver. Insert 2 pcs batteries type
АА/1,5V keeping the polarity. Secure the battery compartment with the cover.
Functions:
When the button is pressed for the first time, the power supply of the music and vibration box is turned on.
When the button is pressed second time, the vibration function is activated.
The third time you press the button, melodies are activated.
The fourth time you press the button, the music and vibration box is switched off.
IMPORTANT!
Follow thoroughly the instructions for use and assembly steps given in the figures in
this manual.
CAUTION!
CHECK IF THE FIXING IS SECURE AFTER EACH ASSEMBLY STEP! Make sure all pins
show through the respective openings.
ASSEMBLY INSTRUCTIONS
FUNCTIONS
