1
2
4
5
3
6
Attach the Front Normal Wheels │ 8
Normal wheel
Remove all the parts from the front axle.
1. Slide a
Ø12 washer
onto the front axle.
2. Slide a
bushing
onto the front axle.
3. Slide a
normal wheel
onto the front alxe. Ensure the bushing match with the
driving wheel.
4. Slide a
Ø12 washer
onto the front axle.
5. Tighten a
Lock nut
to the end of the front axle with a spanner.
6. “Snap” the
hubcap
to the wheel.
Repeat the above procedure to assemble the other normal wheel.
Front axle
Front Bottom View
GAP
After assembling any wheel to the axles, please check the
gap between the screw thread and the collapsible (refer to
below picture), if the gap is too big, please add two or three
washers inside the wheel, but after tightening the nut outside
the wheel, please turn the wheel by your finger to check if the
wheel can run smoothly, this is very important, because if the
wheel can run smoothly, it is ok, but if the nut press the wheel
and the wheel can’t run smoothly, the motor will be broken
easily! Then you need to decrease one or two washers to
make sure the wheel can run smoothly!
