MCDV2 Motorcycle DVR 15
handlebar controller. If that can be done in the shed there will be less glare from
the screen.
Power Supply
C (Red) to Accessory power
Connect - GND (Black) to electrical Ground
Device should be fused for protection (2A)
Bullet Cameras x 2
Front and Rear cameras to be mounted where a clear
view is possible. Do not obstruct the lens. Check
picture on the DVR screen to ensure the camera is
aligned correctly and can capture the view required
before fixing in place. Aim to minimise vibration.
GPS Receiver
Mount under plastic or in the open, this must not be covered by
metal and should not be close to other antennas or high power
devices.
Handlebar Controller
Attach to the handlebars using the strap included or you can use
cable ties. This should be a position where the rider can use their
thumb to operate the buttons safely.
All cables are included and should be sufficiently
long for standard motorcycles. Excess cable should
be coiled and held in place with cable ties.
! Do not cut the cables
! Do not bend too tightly or crush the cables
