04
Filling Screws for the Adjustable Mattress Base
The cot comes with Filling Screws (x4) already located in the upper holes of the End
Panels. If changing the Mattress Base from the lower to the higher position, you must
swap over the Filling Screws. It is important that the Filling Screws are replaced into the
open holes. Ensure they are secured tightly with the Allen Key and check regularly that
they do not loosen.
Assembly Instructions
It is preferable that two people assemble the cot in the room in which the cot is to
be used. As small parts are involved in assembly, children should be kept clear of
the assembly area. Dispose of all packaging material immediatey after the cot is
assembled.
This cot has an adjustable height base for a high or low position.
With base in high position
- this is for use when your baby is young and cannot sit up
unaided.
With base in low position
- this is the normal position for an active baby which can sit
up unaided.
NOTE:
For safe transit, the Drop Side Panel is fitted with rubber caps over each protruding pin.
Please remove the rubber caps prior to assembly, and dispose of immediately to avoid
them becoming a swallowing/choking hazard.
Rubber cap
Protruding pin
