background image

11

10

Assembly / Operating Instructions

To extend canopy

1.  To extend the canopy, pull forward.
2.  To close the canopy, pull back.

CAUTION: 

The canopy must be fully closed before folding the 

stroller.

Assembly / Operating Instructions

Adjusting the backrest

This stroller has an adjustable backrest. The upright position on the 
backrest is not suitable for use with children less than six months old.
For use with a newborn (0-6mths), the seat should be fully reclined. 
The backrest should only be adjusted to a more upright position 
as the child grows older and is able to support their head without 
assistance.

1.  To operate the backrest; pull backrest adjusting lever upwards 

and push up to 1 of 3 desired positions. Release lever once 

satisfied with position. 

 

CAUTION:

 Do not adjust the backrest while child is in the stroller.

Restraints - Harness

1.  To secure the child in the harness, place left 

hand buckle prong (b) on top of (a).

2.  Hold both left hand buckle prongs (a) and (b) 

together and insert it into buckle housing (e) 
until it snaps into position.

3.  Repeat previous steps for right hand buckle 

prongs (c) and (d).

4.  Once all attached, carefully adjust the harness 

straps by pulling each slider (f) until the desired 

fit is achieved in the lap, shoulder and crotch 

straps. 

5. 

To release the buckles, squeeze the top and 

bottom prongs (a) and (b), (c) and (d) together 
until harness disengages.

CAUTION: 

Always adjust the harness when 

changing the seating position of the child.

Top strap

Bottom 

strap

To adjust waist strap

1.  To loosen waist strap, push up both top and 

bottom straps through buckle as circled in 
diagram.

2.  To place waist strap in desired position, slide 

the bottom strap into position then pull the top 
strap and tighten into position.

(a), (b): Left hand buckle prongs
(c), (d): Right hand buckle prongs
(e): Buckle housing
(f): Strap adjustment sliders

f

f

f

f

f

a

b

c

d

e

Содержание Epix 015710









Отзывы: