H03743:11/04
3
INSIDE F
ACE
FOOTBOARD
ASSEMBLY
F
O
THREADED
INSERT
P
F
F
THREADED
INSERT
N
M
S
TEP
3 - D
IAGRAM
3:A
TTACH
P
OSTS
AND
D
OWELS
TO
E
NDS
D
S
M
I
ENLARGED
VIEW
The side of the bottom rail with the threaded inserts will face the inside of the crib as shown. See
ENLARGED VIEW
. Hold End
M
in
upright position and hand thread (two or three turns) Pan Head Screws
I
into the top threaded insert. Place the screw head through
the large keyhole in
D
and
E
(now attached to Stabilizing Bar
S
) and allow the Pan Head Screw
I
to slide into the slot at the top of
the keyhole. Align the bottom threaded insert in End
M
with the bottom locator hole in
D
and
E
and thread Pan Head Screw
I
into
the threaded insert. Tighten Pan Head Screws
I
securely using a #2 Phillips screwdriver or a Flat Tipped screwdriver. Repeat this
procedure for attaching each End Plate
D
and
E
to Ends
M
. Make sure all (8) Pan Head Screws
I
are tightened securely.
SEE
ENLARGED
VIEW
S
TEP
4 - D
IAGRAM
4:A
TTACH
S
TABILIZING
B
ARS
TO
E
NDS
Lay the four parts on a soft surface (carpet) as shown. Insert Allenhead Bolt
F
through the two top holes in Foot Post
O
&
P
and into
the threaded inserts in the top rail of End
M
and Top Dowel
N
. The groove on the underside of the Dowel
N
fits on the top edge of
the top rail on End
M
. Hand thread Allenhead Bolts
F
into the threaded inserts two or three turns and leave lose. Insert Allenhead
Bolts
F
into the opening in the bottom rail, through the locator holes and hand thread into the threaded insert in Posts
O
&
P
. Once
all holes are properly aligned and Allenhead Bolts
F
are partially threaded into their threaded inserts, tighten securely using Allen
Wrench
J
. Do not overtighten and cause the head of the Allenhead Bolts to dig into the wood. Follow the same procedure for the
assembly of both ends. After completion, one assembly will become a headboard and the other will be a footboard.
THREADED
INSERTS
P
OST
BOTTOM
RAIL
E
M
S
INSIDE
FACE
F
ASSEMBLED
END
SHOWING
OUTSIDE
FACE
HEADBOARD
ASSEMBLY
P
O
N
M
