
ABN 23 604 979 688 Nerta QLD Pty Ltd t/as Chiefs Australia
P:
07 5493 8868
M:
0476 350 552
A:
3/6 Textile Avenue Warana QLD 4575
E:
chiefsaustralia.com
1.
Chemical Selector Switch
The chemical selector switch is used to select the required chemical and corresponds via colour to the
chemical input feeds, i.e. if you select green the chemical line attached to the green input feed will draw that
chemical.
2.
High Pressure water in from pressure cleaner.
A high-pressure connecting hose is required to connect your pressure cleaner to the Injecta Chem. The
length will depend on the distance between your pressure cleaner and Injecta Chem. When this hose is
made up, ensure the correct fittings are attached.
3.
High Pressure water out to the hose reel or gun
Your high-pressure hose connects to this connector w
hich comes standard with a 3/8”
BSP thread.
4.
Chemical input feeds (lid kits supplied for 20L, 25L, 200L or 1000L). This is also where the dosing nozzle to
determine the chemical ratio is inserted. This is generally pre-set on your injector and depending on your
setup you may be supplied with a dosing nozzle kit. Please see the below diagram for more information.
Please note that these dosing nozzles are specifically setup for your wash bay requirements and it
is VERY
IMPORTANT
that these nozzles are not tampered with or removed as this will strengthen the soap to water
ratio and at higher concentrations could cause damage.