CHIEF XVM1X1U, Руководство по установке

Страница: 6 / 12

XVM1X1U Installation Instructions
6
3. Place clamp brackets (G) on columns with the top hole on
the brackets lined up with the fifth holes from the bottom of
the columns. (See Figure 3)
IMPORTANT ! : The upper and lower clamp brackets (G)
must be installed exactly 36" apart in order for the
uprights to fit correctly.
4. Use 5/16-18 x 4 1/2" button head cap screw (N), two 5/16"
washers (R) and 5/16-18" lock nut (V) to secure each clamp
bracket (G) to column. (See Figure 3)
5. Use four 5/16-18 x 3/4" button head flange screws (Q) to
secure each attached clamp bracket (G) to a quick connect
base (H). (See Figure 4)
Figure 4
6. Install two 5/16-18 x 3/4" button head flange screws (Q) into
the top holes on each quick connect base (H). (See Figure
5)
Figure 5
7. Hang rails (D) into screws installed in previous step to quick
connect bases (H). (See Figure 5)
8. Install two 5/16-18 x 3/4" button head flange screws (Q) into
the lower holes on each quick connect base (H) to secure
rails (D) to quick connect bases. (See Figure 6)
9. Tighten all 5/16-18 x 3/4" button head flange screws (Q).
Figure 6
Display Installation
1. Place display face down on a soft, non-abrasive surface.
NOTE:
For best access, route display cables through columns
prior to display installation. See Cable Management
section for details.
CAUTION:
Using screws of improper size may damage
your display! Only use hardware provided to mount display.
2. Use M16 x 90mm socket head cap screws (Y) and spacers
(AA) to connect interface brackets (L) to back of display.
(See Figure 7)
Figure 7
(H)
(Q) x 4
5
(G)
(Q) x 2
7
6
(H)
(D) x 2
(Q) x 2 8
(Y) x 4
2
(AA) x 4
(L) x 2