CHIEF WP2 S Series, Руководство по установке

Страница: 9 / 16

Installation Instructions WP2XS, WP2XUS
9
10. Place wall plate (E) over anchors and align mounting holes
in wall plate with holes in anchors. (See Figure 8)
11. Insert Grade 2 or better 1/4-20 x 1-3/4" Phillips pan head
screws (not included) through Grade 2 or better 1/4" washer
(not included), corresponding mounting hole on wall bracket
and into Snap-Toggle (not included) and tighten until flush
against mount. DO NOT overtighten! (See Figure 8)
12. Repeat Steps 10 and 11 for remaining 3 mounting holes.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
EQUIPMENT FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Overtightening of
mounting hardware can damage the steel studs. DO NOT
overtighten mounting hardware!
Figure 8
Installing Short Throw Projector Arm to Wall Plate
1. Lower projector arm (A) onto wall plate (E), ensuring that
tabs on projector arm slide into slots on wall plate. (See
Figure 9)
2. Fasten projector arm (A) to wall plate (E) using four
M4 x 12mm Phillips head cap screws (J). (See Figure 9)
Figure 9
3. Insert and slightly tighten one M5 x 35mm Phillips head cap
screw (H) into wall plate (E). (See Figure 10)
Figure 10
Drywall
Anchor Metal Channel
(E)
x 4
11
Steel Stud
x 4
(side view)
(A)
(E)
1
Tab
Slot
(J) x 4
2
3
(H) x 1
(E)