CHIEF WP2 S Series, Руководство по установке

Страница: 6 / 16

WP2XS, WP2XUS Installation Instructions
6
INSTALLATION
The WP2XS/WP2XUS short throw projector mounts are
designed to be mounted to an 8" concrete, 8"x8"x16" concrete
block, 2" x 4" wood studs (16" on center), or steel studs wall.
NOTE:
Proceed to the Concrete or Concrete Block , Wood
Studs or Steel Studs Installation section, as
appropriate for installation.
Concrete or Concrete Block Installation
1. Determine mounting location on wall.
2. Using wall plate (E) as a template, mark four holes through
mounting holes in wall plate. (See Figure 1)
3. Drill four 3/8" holes at marked locations in wall. (See Figure 1)
4. Install four anchors (K) into drilled holes. (See Figure 1)
5. Install four 5/16 x 2-1/2" hex head lag screws (G) through
four 5/16" washers (F), holes in wall plate (E) and into four
anchors (K). (See Figure 1)
NOTE:
Proceed to Install Short Throw Projector Arm to
Wall Plate section to continue installation.
Figure 1
Wood Studs Installation
1. Determine mounting location on wall. Use a stud finder to
locate studs.
2. Using wall plate (E) as a template, mark four holes through
mounting holes in wall plate. (See Figure 2)
3. Drill four 7/32" holes at marked locations in wall. (See
Figure 2)
4. Install four 5/16 x 2-1/2" hex head lag screws (G) through
four 5/16" washers (F), holes in wall plate (E) and into four
pilot holes. (See Figure 2)
Figure 2
NOTE:
Proceed to Install Short Throw Projector Arm to
Wall Plate section to continue installation.
2
3
x 4
4
(K) x 4
5
(G) x 4
(E)
(F) x 4
2
3
x 4
(E)
4
(G) x 4
(F)